Hhr manual key release

The quick fix for this is there is a plastic plug on the under side of the steering column. Inside you have to feel for the end of that solenoid and depress it to release the key. GM TSB #  · Battery dead, key stuck in ignition can't open doors or hatch to get to battery in trunk HHR remove the rear seat ; if needed; crawl to the back of the hatch and release the hatch lock from inside using a blade screwdriver or, have a locksmith at the dealer make a .  · The contact owns a Chevrolet Hhr. The contact stated that the key failed to release from the ignition. The vehicle was previously repaired according to NHTSA campaign number: 14v (electrical system). The dealer stated that the recall repair would not have caused the type of failure the contact was experiencing.

Hold the start button on the remote for 3 seconds (commonly a loop symbol) until the engine starts. Press the unlock button, insert the key into the ignition and turn it to the "on" position. The car will not shift out of park until the key is inserted and the ignition is switched to on. If left unattended the engine will turn off after 10 minutes. It has to have voltage to activate the release. That voltage comes from the brake light circuit. The computer doesn't read the release switch. Don't remove the button, or it won't work. It also stops you from going to drive and reverse by accident. Going down the road at 60mph and something bumps the shifter to reverse, Good Bye Transmission. Manual operation In case of power failure use key unlock the lock and pull down the SLAC SLIDING GATE OPERATOR 9 release bar about 90 degree to open or close gate manually, use the release key as follow: z Fit the supplied key in the lock. z Turn the key and pull down the release bar about 90 °to release the gear.

Battery dead, key stuck in ignition can't open doors or hatch to get to battery in trunk HHR remove the rear seat ; if needed; crawl to the back of the hatch and release the hatch lock from inside using a blade screwdriver or, have a locksmith at the dealer make a new key by code using your vin number. It is still possible to open the trunk manually, but you must be inside the rear of the HHR to do it. Step 1 Enter the HHR and position yourself inside the rear area just behind the liftgate. The rear lift gate on my Chevy HHR will not release. I have tested the switch (by the license plate) and the solenoid on the latch and found them both to work fine. There is a blue and a brown/wh read more.